HTC 500 - Control Panel Description

Machine Description
HTC 500
12 1.0
3.2. Description of Controls – Control
Panel
The picture below shows the machine's control panel:
DUTY
RESET
REW 0 FWD OFF ON
SPEED
EM-STOP
16
5
4
3
2
Figure 3-3 Control panel
1. EM-STOP - Emergency stop switch: In an
emergency, press the switch to cut the power
to the machine.
2. SPEED - Rotational speed: Regulates the
rotational speed of the machine's grinding
discs.
3. ON/OFF - Start/stop the machine's functions:
Turn the knob to "ON", to activate the
machine's functions and to prepare for
starting. Turn the knob to "OFF", to switch off
the machine's functions.
4. REW/FWD- Start/stop the grinding discs'
rotation and direction of rotation. Turn the
knob to "0", to stop the rotation.
5. RESET -Resetting the electronics: If the
machine experiences an error, it can be
reset by pressing and holding the button
in for two seconds. Any error code is