HTC 500 - Preparations for Wet Grinding

HTC 500
Usage
1.0 21
Note!
The dust extractor's suction hose must be connected to the
appropriate socket on the machine. Adjust the dust extractor to
match the grinder's capacity.
2. Inspect the floor carefully and remove any objects sticking
up, such as reinforcement rods or bolts, and any debris that
could get caught in the machine.
3. Attach the appropriate tool to the machine, see
under Fitting grinding tools on page 19.
4. Set the handle to the working position, see Figure
4-1 on page 16.
4.7. Preparations for wet grinding
Warning!
Check that the splash guard is fitted.
1. Always use wet suction when wet grinding.
Tip!
Never use a dust extractor, as blockages may develop in the dust
extractor's suction hose and filter.
2. Inspect the floor carefully and remove any protruding
objects, such as reinforcement rods or bolts, and any debris
that could otherwise get caught in the machine.
3. Attach the appropriate tool to the machine.
4. Set the handle to the working position, see Figure
4-1 on page 16.
Warning!
Only use cold water with no chemical additives.