HTC 650 HDX - Preparations for Dry Grinding; Preparations for Wet Grinding

HTC 650 HDX
Usage
1.0 23
3. Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer - see Figure
4-10 on page 22.
4.6. Preparations for dry grinding
Warning!
Check that the splash guard is fitted.
1. Connect a dust extractor to the machine. For dust extractor
models, see under the Suction System tab in the HTC
Product Catalogue.
Note!
The dust extractor's suction hose must be connected to the
appropriate socket on the machine. Adjust the dust extractor to
match the grinder's capacity.
2. Inspect the floor carefully and remove any objects sticking
up, such as reinforcement rods or bolts, and any debris that
could get caught in the machine.
3. Attach the appropriate tool to the machine, see
under Fitting grinding tools on page 21.
4. Set the handle to the working position, see Figure
4-2 on page 17.
4.7. Preparations for wet grinding
Warning!
Check that the splash guard is fitted.
1. Always use wet suction when wet grinding.
Tip!
Never use a dust extractor, as blockages may develop in the dust
extractor's suction hose and filter.