HTC GL 40 D - Notes

Safety HTC GL 40 D
6 2.0
Warning!
Do not rinse off the dust extractor, as moisture can penetrate to the electrical
parts and damage the side duct fan.
Warning!
Do not rinse off the dust extractor, as moisture can penetrate into the absolute
filter and the sock filter.
Warning!
The dust extractor may only be used and moved on level surfaces. There is a
risk for crush injuries, if it should start to roll.
Warning!
Connect the dust extractor to an earth fault breaker.
Warning!
If handled carelessly, the dust extractor can overturn and cause both personal
injury and damage to the equipment.
Warning!
There is a risk of crush injuries while lowering to the transport position. Make
sure your hands are not in the way when the guide packet drops into the slot.
Warning!
There is a risk for crush injuries when the dust extractor is lowered to the
service position. Make sure your hands are not in the way when the upper
cylinder sections tips against the handle.
2.3 Notes
Note!
The dust extractor is best used together with HTC's grinding machines in
connection with dry grinding of stone and concrete floors, and in accordance
with HTC's recommendations.
Note!
Never use a dust extractor in connection with wet grinding, as it may cause
blockages in the dust extractor's suction hose and damage the sock filter,
absolute filter and side duct fan.
Note!
Only use original spare parts from HTC for the dust extractor. Otherwise,
neither the CE marking nor the warranty will be valid.