HTC GL 40 D - Changing the Fuse

HTC GL 40 D Usage
2.0 23
4.8.2 Changing the fuse
1. Cut the power to the dust extractor by pulling the plug out of the electrical
socket, see Figure3-2, page9.
2. Open the electrical cabinet.
3.
Raise the fuse holder, see position 3 in Figure4-10, page22.
4.
Pull out the fuse holder, see position 4 in Figure4-10, page22.
5. Change the fuse.
6. Reassemble the fuse holder.
7. Lower the fuse holder.
8. Close the electrical cabinet.
9. Connect the dust extractor to the mains supply by plugging in the plug.
10. Try to start the dust extractor by pressing the "I" button.