108 Getting Connected
Notes
• Wi-Fi connects to the default network that is available on your phone.
However, GPRS starts by default if your phone does not detect any Wi-Fi
signal.
• In Comm Manager, click Settings > WLAN Settings > Connection Status
to check the current connection status and signal quality of each Wi-Fi
channel.
• Configure your phone so that the Wi-Fi function turns off automatically
when no signal is detected to conserve battery power. In Comm Manager,
click Settings > WLAN Settings > Wi-Fi > Menu > Wi-Fi Settings.
To create a new Wi-Fi connection
If the Wi-Fi connection you want to connect to is not in the list, you can
create a new Wi-Fi connection.
1. On the Home screen, click Start > Settings > Connections >
WLAN Settings > Wi-Fi > New.
2. Enter the Network name and Network type and click Next.
Note If you want only to connect directly to another device or computer, and not
to a network through an access point, select This is a device to device (ad-
hoc) connection.
3. Select the Authentication type and Data encryption, then click
Next. For TKIP, AES, or WEP data encryption, enter the needed
information in the remaining fields.
4. Select Use IEEE 802.1x network access control to use Extensible
Authentication Protocol (EAP). Select the EAP type depending on the
type of authentication. Click Finish.
To Next Page
Loading...
