LP-648 Rev. 002 Rel. 002 Date 9.16.20
77
Limited Warranty for UFTC Boilers
HTP warrants this boiler and its components to be free from
defects in material and workmanship according to the following
terms, conditions, and time periods. UNLESS OTHERWISE NOTED
THESE WARRANTIES COMMENCE ON THE DATE OF INSTALLATION.
This limited warranty is only available to the original consumer
purchaser (herinafter “Owner”) of this boiler, and is non-transferable.
Residential Use Warranty
Ten (10) years – Heat Exchanger, Five (5) Years – Components
Commercial Use Warranty
Five (5) years – Heat Exchanger, One (1) Year – Components
Use Denitions - Residential Heating means heating a single family
dwelling. This dwelling must be either: a) owned and resided in by the
original purchaser; or b) a residential rental property that services a
single dwelling in which the original purchaser resides on a permanent
basis. Commercial Use refers to all other applications.
COVERAGE
A. During the rst year after the original date of installation, HTP warrants
that it will repair or replace, at its option, any defective or malfunctioning
component of the boiler with a component of equivalent size and current
model. Replacement components will be warranted for ninety (90) days.
B. Should a defect or malfunction result in a leakage of water from
the boiler within the above-stated warranty periods due to defective
material or workmanship, malfunction, or failure to comply with the
above warranty, with such defect or malfunction having been veried
by an authorized HTP representative, HTP will replace the defective or
malfunctioning boiler with a replacement of the nearest comparable
model available at the time of replacement. The replacement boiler
will be warranted for the unexpired portion of the applicable warranty
period of the original boiler.
C. In the event of a leakage of water of a replacement boiler due to
defective material or workmanship, malfunction, or failure to comply
with the above warranty, HTP reserves the right to refund to the Owner
the published wholesale price available at the date of manufacture of the
original boiler.
D. If government regulations, industry certication, or similar standards
require the replacement boiler or component(s) to have features not
found in the defective boiler or component(s), the Owner will be charged
the dierence in price represented by those required features. If the
Owner pays the price dierence for those required features and/or to
upgrade the size and/or other features available on a new replacement
boiler or component(s), the Owner will also receive a complete new
limited warranty for that replacement boiler or component(s).
E. If at the time of a request for service the Owner cannot provide a copy
of the original sales receipt or the warranty registration, the warranty
period for the boiler shall then be deemed to have commenced thirty
(30) days after the date of manufacture of the boiler and NOT the date of
installation of the boiler.
F. This warranty extends only to boilers utilized in heating applications
that have been properly installed by qualied professionals based upon
the manufacturer’s installation instructions.
G. It is expressly agreed between HTP and the Owner that repair,
replacement, or refund are the exclusive remedies of the Owner.
OWNER RESPONSIBILITIES
The Owner or Qualied Service Technician must:
1. Have a relief valve bearing the listing marks of the American Society
of Mechanical Engineers (ASME) installed with the boiler assembly in
accordance with federal, state, and local codes.
2. Maintain the boiler in accordance with the maintenance procedure
listed in the manufacturer’s provided instructions. Preventive
maintenance can help avoid any unnecessary breakdown of the boiler
and keep it running at optimum eciency.
3. Maintain all related system components in good operating condition.
4. Use the boiler in an open system, or in a closed system with a properly
sized and installed thermal expansion tank.
5. Use the boiler at water pressures not exceeding the working pressure
shown on the rating plate.
6. Keep the boiler free of damaging scale deposits.
7. Make provisions so if the boiler or any component or connection
thereto should leak, the resulting ow of water will not cause damage to
the area in which it is installed.
WARRANTY EXCLUSIONS
This limited warranty will not cover:
1. Any boiler purchased from an unauthorized dealer.
2. Any boiler not installed by a qualied service technician, or installations
that do not conform to ANSI, CSA, and/or UL standards, as well as any
applicable national or local building codes.
3. Service trips to teach the Owner how to install, use, maintain, or to
bring the boiler installation into compliance with local building codes
and regulations.
4. The workmanship of any installer. The manufacturer disclaims and does
not assume any liability of any nature caused by improper installation,
repair, or maintenance.
5. Electricity or fuel costs, or increased or unrealized savings for same, for
any reason whatsoever.
6. Any water damage arising, directly or indirectly, from any defect in the
boiler or component part(s) or from its use.
7. Any incidental, consequential, special, or contingent damages or
expenses arising, directly or indirectly, from any defect in the boiler or
the use of the boiler.
8. Failure to locate the boiler in an area where leakage of the tank or water
line connections and the relief valve will not result in damage to the area
adjacent to the boiler or lower oors of the structure, as well as failure to
install the boiler with properly designed containment measures.
9. Any failed components of the system not manufactured by HTP as part
of the boiler.
10. Boilers repaired or altered without the prior written approval of HTP.
11. Damages, malfunctions, or failures resulting from failure to install the
boiler in accordance with applicable building codes/ordinances or good
plumbing and electrical trade practices.
12. Damages, malfunctions, or failures resulting from improper
installation, failure to operate the boiler at ring rates or pressures not
exceeding those on the rating plate, or failure to operate and maintain
the boiler in accordance with the manufacturer’s provided instructions.
13. Failure to operate the boiler in an open system, or in a closed system
with a properly sized and installed thermal expansion tank.
14. Failure or performance problems caused by improper sizing of the
boiler, expansion device, piping, or the gas supply line, the venting
connection, combustion air openings, electric service voltage, wiring or
fusing.
15. Damages, malfunctions, or failures caused by improper conversion
from natural gas to LP gas or LP gas to natural gas.
16. Damages, malfunctions, or failures caused by operating the boiler
with modied, altered, or unapproved components, or any component
/ attachment not supplied by HTP.
17. Damages, malfunctions, or failures caused by abuse, accident, re,
ood, freeze, lightning, electrochemical reaction, acts of God and the like.
18. Failures (leaks) caused by operating the boiler in a corrosive or
contaminated atmosphere.
19. Damages, malfunctions, or failures caused by operating an empty or
partially empty boiler (“dry ring”), or failures caused by operating the
boiler when it is not supplied with water, free to circulate at all times.
20. Any damage or failure of the boiler due to the accumulation of solid
materials or lime deposits.
21. Any damage or failure resulting from improper water chemistry. See
below for water chemistry requirements.
To Next Page
Loading...
