3Product Features (in Fat AP and Fit AP
Modes)
3.1 WLAN Features
WLAN features supported by the AP are as follows:
Complies with IEEE 802.11a/b/g/n/ac, supports 3x3 MIMO, and provides a maximum
rate of 1.75 Gbit/s.
Maximum ratio combining (MRC)
Space time block code (STBC)
Low-density parity-check (LDPC)
Maximum-likelihood detection (MLD)
Frame aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Tx/Rx)
802.11 dynamic frequency selection (DFS)
Short guard interval (GI) in 20 MHz, 40 MHz, and 80 MHz modes
Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to
implement priority-based data processing and forwarding
Automatic and manual rate adjustment
WLAN channel management and channel rate adjustment
NOTE
For details about WLAN channel management, see the Country Code & Channel Compliance
Table.
Automatic channel scanning and interference avoidance
Service set identifier (SSID) hiding
Signal sustain technology (SST)
Unscheduled automatic power save delivery (U-APSD)
Control and Provisioning of Wireless Access Points (CAPWAP) in Fit AP mode
Automatic login in Fit AP mode
Extended Service Set (ESS) in Fit AP mode
Wireless distribution system (WDS) in Fit AP mode
To Next Page
Loading...
