Huawei AR1200 Series - Enabling Remote Access Services on the SAE Board

Pre-configuration Tasks
l Installing the operating system and drivers on the SAE board.
l Configuring the IP address, subnet mask, and default gateway of the SAE board to ensure
the normal connection between the user terminal and SAE board.
7.2.2 Enabling Remote Access Services on the SAE Board
Before logging in to the SAE board remotely, enable remote access services on the operating
system of the SAE board.
Context
The following describes how to enable remote access services on the SAE board that runs
Windows Server 2008 R2.
By default, remote desktop access and Telnet services are disabled on Windows Server 2008
R2.
Procedure
l Enable the remote desktop access service.
1. Power on the SAE board and enter the Windows Server 2008 R2 operating system.
Choose Start > Control Panel > System and Security > Allow remote access.
Figure 7-5 System and Security
2. Choose Allow connections for computers ... or Allow connections only from
computers ..., and click OK.
Huawei AR1200&2200&3200 Series Enterprise Routers
SAE Card Usage Guide 7 Managing the SAE Board
Issue 02 (2012-08-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
41