Figure 7-11 Telnet Properties
----End
7.2.3 Logging In to the SAE Board Remotely
This section describes how to log in to the SAE board remotely.
Context
You can log in to the SAE board by using Windows command line interface (CLI) or remote
desktop software. You can also use non-Windows remote desktop software as alternatives.
Before establishing a remote connection to the SAE board, ensure that the user name and
password have been configured for the operating system of the SAE board. The following
describes how to log in to the SAE board using Windows XP CLI and remote desktop software.
Procedure
l Logging In to the SAE Board Using Windows CLI
1. In a computer that runs Windows XP, choose Start > Programs > Accessories >
Command Prompt.
2. Run the telnet ip-address command to remotely log in to the SAE board.
Huawei AR1200&2200&3200 Series Enterprise Routers
SAE Card Usage Guide 7 Managing the SAE Board
Issue 02 (2012-08-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
46
To Next Page
Loading...
