Table 3-96 LTE antenna interface attributes
Attribute Description
Connector type SMA-K (screw threads outside and a hole
inside)
Standards compliance
l GSM/GPRS/EDGE: bands 2/3/5/8
l WCDMA/HSDPA/HSUPA/HSPA+:
bands 1/8
l LTE FDD: band 3
Maximum rate
l Global System for Mobile
Communications circuit switched (GSM
CS): uplink rate of 14.4 kbit/s and
downlink rate of 14.4 kbit/s
l General Packet Radio Service (GPRS):
uplink rate of 85.6 kbit/s and downlink
rate of 85.6 kbit/s
l Enhanced Data Rates for GSM
Evolution (EDGE): uplink rate of 236.8
kbit/s and downlink rate of 236.8 kbit/s
l Wideband Code Division Multiple
Access circuit switched (WCDMA CS):
uplink rate of 64 kbit/s and downlink
rate of 64 kbit/s
l WCDMA packet switched (PS): uplink
rate of 384 kbit/s and downlink rate of
384 kbit/s
l High Speed Packet Access Plus (HSPA
+): uplink rate of 5.76 Mbit/s and
downlink rate of 21.6 Mbit/s
l Dual Carrier High Speed Packet Access
Plus (DC-HSPA+): uplink rate of 5.76
Mbit/s and downlink rate of 42 Mbit/s
l Frequency Division Duplex-Long Term
Evolution (LTE FDD): uplink rate of 50
Mbit/s and downlink rate of 150 Mbit/s
Network protocol
LTE, WCDMA, GSM
Antenna type
l 6.3.2 LTE Whip Antenna
l 6.3.3 LTE Indoor Remote Antenna
l 6.3.4 Outdoor LTE Antenna
DI/DO Interface
The DI/DO interfaces are used to detect voltage level signals or deliver instructions. Table
3-97 lists DI/DO interface attributes.
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
3 Chassis
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 183
To Next Page
Loading...
