NOTE
l The TXD and RXD signals are defined based on signal stream direction on the industrial switching
router, and the corresponding pins must be connected to the pins of RXD and TXD on the remote
device.
l A console cable does not have an RTS, CTS, DSR, or DTR signal wire, and therefore does not
support hardware-based flow control.
l Pins not listed in the table are not connected.
Connection
A console cable is connected as follows:
l The RJ45 connector is connected to the console interface of the industrial switching
router.
l The DB9 connector is connected to a maintenance terminal, generally a computer.
Ordering Information
Each industrial switching router is configured with a console cable, which is delivered in the
installation accessory package.
Table 6-103 provides the console cable ordering information.
Table 6-103 Console cable ordering information
Part Number
Description Remarks
04040838 Single Cable, Serial Port
Cable, 3m, D9F,
CC2P0.32PWG1U, MP8-
VI, S3026V
Standard configuration
6.19 8AS Cable
Description
An 8AS interface card can be used in four scenarios, where different cables are required.
Table 6-104 describes the scenarios and applicable cables.
Table 6-104 Types and application scenarios of 8AS cables
Cable Type
Application Scenario Description
Straight-through cable Financial dumb terminal The pin assignments at both
ends of the cable are the same.
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
6 Cables
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 726
To Next Page
Loading...
