9
After a connection between your device and the client is set up, you can access the
Internet using the modes listed in the following table.
Mode Description
Auto After being powered on, the device will automatically connect to the
Internet. Once connected, the device will not automatically disconnect
from the Internet.
Manual
Press , when turns steady green, that indicates you are
connected to the Internet.
Log in to the web management page, and then connect to or
disconnect from the Internet as prompted.
On
Demand
After being powered on, if there is data being transferred, the device
will automatically connect to the Internet. If no data is transferred
within a pre-defined period, the device will automatically disconnect
from the Internet.
Note:
Select an appropriate mode according to your data service charging plan. For example, if
you are charged according to the length of time you are connected to the Internet, it is
recommended that you select manual mode. For details about your data service
charging plan, contact your service provider.
6 Logging in to the management page
You can configure and manage the device settings using the web management page.
1. Launch a web browser, and enter http://192.168.1.1 in the address bar.
2. Enter the password, and log in to the web management page. The default
password is printed on the device label.
Note:
To protect your device, only one user can log in to the web management page at a
time.
To protect your account, change the password promptly. For details, see the help
information on the web management page.
To Next Page
Loading...
