6
(Optional) Installing an External Antenna
In areas with poor network coverage, connect an external antenna to the device's
external antenna port. Screw the external antenna in fully, as shown in the following
figure.
Note:
Skip this section if you do not need to connect an external antenna to the device.
Before using an external antenna, log in to the web management page
(http://192.168.1.1) and set antenna mode to external. For details, see the help
information on the web management page.
Only use the external antenna indoors.
You cannot switch between the internal antenna and the external antenna while
using a voice or data service.
(Optional) Connecting to a USB device
Connect a USB flash drive, portable hard disk drive, or USB printer to the device's USB
port, as shown in the following figure. For details, see the help information on the
web management page.
Note:
Do not connect a computer to the device's USB port.
The device's USB port can supply a maximum current of 500 mA to power connected
USB devices. If the current required by a portable hard disk drive (or other
peripherals) connected to the device is higher than 500 mA, the device may fail to
recognize the hard disk drive. In this case, use an auxiliary power supply for the hard
disk drive. For more information, contact your service provider.
To Next Page
Loading...
