13
Disabled: The device does not broadcast the SSID of the
WLAN. Before accessing the WLAN, a user must obtain the
SSID of the WLAN. In this case, the WLAN security is
improved.
For the convenience of users accessing the
WLAN, you can select Enabled for SSID
Broadcast when you configure the WLAN
setting. After the setting, you can select
Disabled to improve the WLAN security.
Selecting a WLAN Channel
Channel: It refers to the channel that the device works with. If
you do not know which channel to select, select Auto Select
and the device can automatically search for the channel.
WDS Mode
Disable: Disable all WDS function.
Lazy Mode: Turn on WDS function; DUT will learn
automatically from WDS packet.
Bridge Mode: Turn on WDS function, the peer WDS APs are
listed in the "AP MAC Address" field below. In this mode, AP
will not send beacon out and will not deal with probe request
packets, therefore STA will not be possible to connect with it.
Repeater Mode: Turn on WDS function, the peer WDS APs
are listed in the "AP MAC Address" field below.
Phy Mode
CCK: Modulation method used for 802.11b, g, n mode.
OFDM: Modulation method used for 802.11g, 802.11b/g
mixed mode.
HTMIX: Modulation method used for 802.11b/g/n mixed
mode.
GREENFIELD: Modulation method used for 802.11/n mode.
Encryption Mode
None: Encryption service is disabled.
WEP: Please configure the WEP encryption key in the
Wireless > Security Setting section.
TKIP: Input the WPA encryption key.
AES: Input the WPA encryption key.
In the WEP mode, devices should keep the
same security settings to make the WDS work.
In the TKIP/AES mode, the key in the WDS key
field should keep the same value to make the
WDS work.
To Next Page
Loading...
