10
Click Internet Settings to go to WAN Interface
configuration page for the device mode settings.
Choose Gateway as the Device Mode and then
configure the gateway releated settings in the
corresponding fields.
DHCP Client: Set DUT to get IP address dynamically
from the local DHCP server.
Use MAC Clone: Click Clone button to use the local PC
MAC as the device MAC address.
PPPoE Client: Input the username and password
according to the local PPPoE server to be permitted to
connect to the server and get IP address dynamically
from the PPPoE server.
Connection Mode: Select the PPPoE access mode.
Keep Alive: The device automatically connects to the
Internet and does not disconnect when no data is
transmitted.
Connect on Demand: The device automatically connects
to the PPPoE server when data transmission exists. When
the duration of no data transmission exceeds the
maximum idle time, the device disconnects the
connection.
Manual Connect: The device connects to the PPPoE
server after you click Connect on the connection page.
Static Config: Input the connection information
according to the local server in these fields.
Choose 3.5G Cilent as the Device Mode and then
configure the PPP 3.5G client related settings in the
corresponding fields.
APN Service(APN): If the service provider provides the
relevant parameters, select Static and enter the APN
value. Otherwise, select Dynamic and the device
automatically obtains the APN value.
Username/Password Service: Select Enable and enter
the username/password value if the internet service
provider (ISP) provides the relevant parameters.
Otherwise, select Disable. The user name and
password is used to obtain the service authorization
To Next Page
Loading...
