Huawei D105 - Advance; Advanced Routing; Upnp

22
Click Advance to configue Advanced Routing and
UPnP function.
Advanced Routing
Click Advanced Routing to configure routing table. A
Static IP Routing is a manually defined path, which
determines the data transmitting route. If your local
network is composed of multiple subnets, you may want
to specify a routing path to the routing table.
Enter the following values as required:
 Destination: Display the IP address that the data packets are
to be sent.
 Host/Net: Choose Host to specify the host IP in the
Destination field that the data packets are to be sent;
otherwise choose Net to specify network IP in the Destination
field that the data packets are to be sent and then also input
the Subnet Mask value.
 Subnet Mask: Input the value in this field if Net is chosen in
the Host/Net field.
 Gateway: Specify the gateway information that the
transmitting data will pass through.
 Interface: Specify the interface information that the
transmitting data will pass through.
Click Apply to confirm to add the static routing; or
Cancel to give up the previous settings; or Delete
Selected after selecting specific entry to delete the
static routing.
UPnP
The Universal Plug and Play (UPnP) service allows
other network users to control your device’s network
features to realize the intelligent interconnection.
Select Enabled/Disabled for UPnP Status to enable
or disable the UPnP service.
Click Apply.
8
Advance
1
2
1
2