14
Using Ethernet (WAN)
1. Use the network cable to connect the CPE to the router.
2. Ensure that the
lights up in steady blue.
3. Log in to the CPE's web management page and configure the parameters of the Ethernet
connection.
Dynamic IP: Does not need to be configured.
PPPoE: Enter the user name and password for a dial-up connection.
Static IP: Select static IP in connection mode and enter the IP address, default gateway address, DNS
server address, and so on.
Note:
The dock does not work when your CPE sources power from a battery only.
For detailed information about the user name, password, IP address, default gateway
address, DNS server address, and other settings, contact your operator.
To Next Page
Loading...
