Huawei EM770 - Page 55

HUAWEI EM770 HSPA PC Embedded Module V100R001
Product Specification
Issue 1
(2008-09-15)
Huawei Confidential: This documents is Huawei Proprietary and Confidential(NDA
Required).It may not be duplicated, neither distributed externally without
prior and written permission of Huawei.
Page
55 of 68
connection test (connect the module to the antennas) can be implemented. The
signal points can also be tested when you maintain and repair the module.
II. Structure of the Debugging board
Figure 5-24 Structure of the debugging board
Note:
1. RF connector: RF switch, bend, female
2. RF connector: coaxial connector, straight, male
3. RF connector: RF switch, straight, female
4. Connector latch: It works with the mini PCI-E connector and is used for fixing the module.
5. Mini PCI-E connector: female, 52-pin, straight
6. SIM card socket: It is used to holding the inserted SIM card.
7. USB connector and mini USB B-type receptacle: Side-plugging USB connector
III. Method for Connecting the Debugging Board
1. Diagram of connecting the module to the CMU200
for faithgofar