17
Vertically
1. Pull out the Handset retaining clip from the slot and turn it around. Then push it back
so that the handset will not fall down when FWT is placed vertically.
2. According to the distance between the two hooks (7.7 cm), hammer two nails into the
wall with 3 mm end left out.
7.7cm
3. Snap the hooks to the nails.
Validating
After installing the FWT, you can make a call to check whether it is correctly installed.
1. Press and hold
to power on your FWT. After connecting the FWT to the power
socket, the
icon appears, indicating that the FWT is powered normally.
2. Lift the handset. In the standby mode, the signal strength icon
appears normally.
3. If you are able to make a call, it indicates that the FWT is installed correctly.
To Next Page
Loading...
