Huawei FusionPower6000 - UPS-1200

Category Default Value Value Range Setting
IP address 192.168.0.10 1.0.0.0–223.255.255.255 Default Value
Subnet mask 255.255.255.0 0.0.0.0–255.255.255.255 Default Value
Gateway 192.168.0.1 1.0.0.0–223.255.255.255 Default Value
MAC address / / Default Value
Address 1 1–254 Default Value
Baud rate 9600 9600, 19200, 115200 Default Value
Parity mode None None, Odd, Even Default Value
Stop bit 1 1–2 Default Value
ModbusTCP Settings ModbusTCP encryption Enable Disable, Enable Default Value
Start address 32 32–44 Default Value
Quantity 0 0–4 Default Value
Start address 16 16–28 Default Value
Quantity 0 0–4 Default Value
Start address 112 / Default Value
Quantity 0 0–12 Default Value
SSID
UPS_WIFI + Last six characters
of the MAC address
/ Default Value
Password Changeme / Default Value
Single Single, Parallel Single
/ 0–12 12
0 0–19 0
Normal mode
Normal mode, ECO, Self-load mode, Converter mode Normal mode
±5%
±5%, ±6%, ±7%, ±8%,
±9%, ±10%
±5%
Non-BSC Non-BSC, Standard BSC mode Non-BSC
≤ 1000
≤ 1000, 1000–2000, 2000–3000,
3000–4000, 4000–5000
Default Value
Disable Disable, Enable Disable
0 0–365
Default Value
1–5 power modules
2.0 0.5–120.0
Default Value
6–10 power modules
1.0 0.5–120.0
Default Value
10–20 power modules
0.5 0.5–120.0
Default Value
5 2–120
Default Value
Disable Disable, Enable
/
Enable Disable, Enable
/
UPS5000-H(1200KVA) Initial Configuration Parameters
Parameter
Comm. Settings
IP Settings
RS485 Settings
Amb. T/H Sensor
Batt Temp Sensor
BMU
WiFi Settings
Dry Contact Settings
Single/Parallel
Requisite modules
Redundant modules
Working mode
ECO voltage range
BSC mode
Altitude(m)
Top outlet fan
Air filter maintenance period(d)
Intra-rack power
module startup delay(s)
Inter-rack power module startup delay(s)
NTC
BCB trips if UPS stops power supply