The
LOS
indicator blinks.
If the LOS indicator blinks once two seconds, check
whether the pigtail fiber is properly connected and the
connector is clean.
If the GPON terminal blinks twice a second, contact the
service provider for help.
The
PON
indicator is off.
Check whether the OPTICAL port and optical fiber is
properly connected.
The GPON terminal fails to register with the upper-layer
device. Contact the service provider for help.
The phone does not ring upon an incoming call but
communication is in normal state when the phone is in off-hook
state.
The GPON terminal provides a maximum of 60 V AC
ringing current voltage. Check whether the ringing current
voltage of the phone is higher than 60 V AC. If it is higher
than 60 V AC, replace it with another phone.
How to reset the GPON terminal?
Press Reset by using a needle-type object.
How can I restore factory defaults?
Press Reset by using a needle-type object for longer
than 10s to restore factory defaults and reset the GPON
terminal. If the indicator is off and then is lit, the system
restarts successfully.
FAQs
10
To Next Page
Loading...
Need help?
General
