Indicator Description
Indicator Status Description
CATV
Steady on
The CATV function is enabled and CATV signals
are received.
Off
The CATV function is disabled or CATV signals
are not received.
TEL1–TEL2
Steady on
The ONT is registered with the softswitch but no
service ows are transmitted.
Blinking Service ows are transmitted.
Off
The ONT is not powered on or fails to be
registered to the softswitch.
LAN1–LAN4
Steady on The Ethernet connection is in the normal state.
Blinking Data is being transmitted on the Ethernet port.
Off The Ethernet connection is not set up.
LOS/PON See Table 2.
POWER
Steady green The terminal is powered on.
Off The power supply is cut off.
Table 1 Indicator status description 1
8
Status
No.
Status
Description
PON LOS
1 Off Off
The GPON terminal is prohibited by the upper-
layer device, contact the service provider for
help.
2
Blinks twice
a second
Off
The GPON terminal attempts to set up a
connection with its upper-layer device.
3 Steady on Off
A connection is set up between the GPON
terminal and its upper-layer device.
4 Off
Blinks once
two seconds
The GPON terminal is not connected to optical
bers or does not receive optical signals.
5
Blinks twice
a second
Blinks twice
a second
The GPON terminal is a rogue terminal,
contact the service provider for help.
6
Blinks once
two seconds
Blinks once
two seconds
The hardware is faulty.
Table 2 Indicator status description 2
To Next Page
Loading...
Need help?
General
