Huawei PowerCube 500 - Solution Overview; Introduction; Features; Model Naming Conventions

6
4. (Optional) Install signal cables for non-P&E cameras. 5. (Optional) Install power cables for non-P&E cameras.
Bullet camera 2
Bullet camera 1
Dome camera
Cable distribution terminal

The power cable for the dome camera can only be connected to
the 24V AC port.

One PC500-300G1 can supply power to one non-P&E dome
camera.

Use waterproof tape to protect the cable distribution terminal
and put it inside the pole.
NOTICE
Bullet camera 1
Bullet camera 2
Dome camera 2
Dome camera 1
6. (Optional) Install the door status sensor.
7. (Optional) Install the dome camera alarm linkage cable.
Dome camera
alarm cable
The alarm cables of the two dome cameras can be connected to
the door status sensor. Select one dome camera for connection
according to the actual situation.
NOTICE