Need help?Do you have a question about the Huawei RTN 905 V100 and is the answer not in the manual?
Safety guidelines for connecting and managing power cables for the RTN 905.
Safety measures for connecting and disconnecting IF jumpers and cables on specific RTN 905 models.
Instructions on safely operating the toggle lever switch on RTN 905 2A/2E units.
Safety guidelines for handling IF jumpers on RTN 905 2A/2E/2F models.
Safety guidelines for handling IF cables on RTN 905 2A/2E/2F models.
Detailed description of ports and indicators on the IDU 905 1A model.
Detailed description of ports and indicators on the IDU 905 2A model.
Detailed description of ports and indicators on the IDU 905 1C model.
Detailed description of ports and indicators on the IDU 905 1E model.
Detailed description of ports and indicators on the IDU 905 2E model.
Detailed description of ports and indicators on the IDU 905 2F model.
Step-by-step guide for mounting the IDU 905 chassis into a standard 19-inch cabinet.
Step-by-step guide for mounting the IDU 905 chassis into an ETSI cabinet.
Step-by-step guide for mounting the IDU 905 chassis into a 23-inch cabinet.
Instructions for securely mounting the IDU 905 chassis onto a wall.
Procedure for placing and securing the IDU 905 chassis on a desk or flat surface.
Optional procedure for installing the E1 panel for the IDU 905.
Safety and handling precautions for installing optical fibers.
Procedure for connecting Ethernet service cables to the IDU 905.
Steps for installing IF jumpers on the IDU 905.
Procedure for connecting IF jumpers to IF cables and the IDU.
Guide for connecting cascade cables for TDM, 1+1, and XPIC functions.
Procedure for connecting COMBO cables for various cascading functions.
Steps to connect an NMS cable to a gateway NE.
Procedure for connecting NMS cables across multiple NEs.
Guide to creating external alarm cables using specific pin assignments.
Procedure for connecting an external alarm cable to the equipment.
Guide to creating asynchronous data cables based on pin assignments.
Procedure for connecting asynchronous data cables to the RTN 905.
Guide to creating external clock cables based on pin assignments.
Procedure for connecting external clock cables to the equipment.
Diagrams illustrating cable connections for various interfaces on the IDU 905.
Steps and precautions for powering on the IDU 905 equipment.
Procedure for configuring network element data using the Web LCT.
Procedure for configuring network element data using a hand-held tool.
Guide for aligning single-polarized antennas for optimal signal reception.
Guide for aligning dual-polarized antennas for optimal signal reception.
Procedure to check the operational status of radio links.
Procedure for preparing and connecting power cables to the connector.
Detailed steps for routing and fastening cables to the power connector.
Instructions for removing the filler panel and installing the MN1 subboard.
To Next Page
General