Huawei S2700 Series - Installing and Removing Device Modules

≥3m
Switch
Network port
surge protector
Power supply
surge protector
OUT
<40cm
IN
Ground bar
ground cable
2.3 Installing and Removing Device Modules
This section describes how to install and remove various modules on the
S2700/3700/5700/6700 series switches.
Installing and Removing a Power Module
CAUTION
l Power modules and fan modules of the S2700/3700/5700/6700 series switches are hot
swappable. The procedures for installing and removing a fan module are the same as the
procedure for installing and removing a power module.
l Before installing a power module, remove the filler panel from the power slot.
Install the power module into the power slot of the chassis and fasten the captive screws on the
panel of the power module. When you remove the power module, reverse the procedure.
S2700&S3700&S5700&S6700 Series Ethernet Switches
Quick Start Guide
2 Device Installation
Issue 12 (2013-07-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
20