Huawei S2700 Series - Connecting Cables

Removing the Filler Panel from the RPS1800 Power Module Slot
Hold the upper edge of the filler panel and pull the filler panel downward. Do not pull the filler
panel horizontally.
√ ×
Installing an RPS1800 Power Module
Move the white button leftward to loosen the ejector lever, and pull out the ejector lever. Install
the power module into the slot and push the ejector lever inside. Move the white button rightward
to lock the ejector lever. When you remove the RPS1800 power module, reverse the procedure.
2.4 Connecting Cables
This section describes how to connect an S2700/3700/5700/6700 chassis to a network.
S2700&S3700&S5700&S6700 Series Ethernet Switches
Quick Start Guide
2 Device Installation
Issue 12 (2013-07-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23