Step 6 After the HyperTerminal starts, choose FileAttributes to display the COMM1 Properties
dialog box, as shown in Figure 3-5. On the Setting tab, select VT100 in the Emulation drop-
down list box. Click OK to complete the setting.
Figure 3-5 Selecting the terminal type
Step 7 Press Enter. At the following command-line prompt, set an authentication password. The system
automatically saves the set password.
Please configure the login password (maximum length 16)
Enter Password:
Confirm Password:
NOTE
After the password for the user interface is set successfully during the first login, you must enter this
password for authentication when you relog in to the system in password authentication mode using this
user interface.
----End
Follow-up Procedure
If the prompt <HUAWEI> is displayed on the screen, it indicates that the Command Line
Interface (CLI) is displayed. In this case, you can enter commands to configure or manage the
S2700/3700/5700/6700. For details on configuration procedures, see the following sections.
S2700&S3700&S5700&S6700 Series Ethernet Switches
Quick Start Guide
3 Logging in to the Device
Issue 12 (2013-07-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
37
To Next Page
Loading...
