Huawei V100R001 - Page 78

FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
71
Indicator
Colo
r
Name
Status
Description
Red
Fault
indicator
Steady on
The converter locks out due to
output overvoltage.
The converter delivers no output
due to internal faults.
Off
The converter is working properly.
Wireless Network Pairing (SW) and IP Address Reset (Default) Buttons
Table 3-41 describes the wireless network pairing and IP address reset buttons.
Table 3-41 Wireless network pairing and IP address reset buttons
Button
Name
Function
Description
Operation Description
Indicator Status
SW
Wireless
network
(802.15.4)
pairing
In non-wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to enter the
wireless network pairing mode.
The RF_Z indicator
is blinking at super
short intervals.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
The RF_Z indicator
is blinking at long
intervals.
Press and hold down the button for
more than 6s to clear network
parameters.
The RF_Z indicator
is on.