PINTAIL BOTTLE/VACUUM SYSTEM
PINTAIL BOTTLE/VACUUM SYSTEM
202V & 202LV (Refer to Figs. 5, 6 & 15)
NOTE: The following steps are for the disassembly
of the 202V and 202LV models only. Please use
these steps in conjunction with the General and
Head/Handle disassembly sections of this manual.
1. Reaching through window of Pintail Bottle (24)
remove Retaining Ring (62) and Washer (63).
2. Remove Pintail Bottle (24).
3. Disconnect tube from Plug & Gasket Assy (54).
4. Remove Adapter (64) and Tube/ Slide Assy (70).
5. Remove End Cap (21) and Spring (19) (Fig. 6).
6. Remove Spacer (22) and O-Ring (68) from spring
side of end cap.
7. From bottle side of end cap, remove Retaining
Ring (66), Tube (67), Wiper Seal (23), Washer
(71) and O-Ring (69).
8. Remove the O-Rings (65) from the inside of the
Adapter and Tube/Slide Assembly (70) (Fig. 15).
13
202 Series Tooling (HK938) Alcoa Fastening Systems
To Next Page
Loading...