10
The Hughes & Kettner Red Box Classic converts Line
Out and Speaker Out signals into balanced, frequen-
cy-compensated signals, enabling a direct feed to a
mixer. The Red Box Classic features two voicing opti-
ons, a 4 x12" cabinet and a 2 x12" combo.
Benets
• No mic required • No sound deviations due to dif-
ferent mics/mic positions • Authentic speaker sound
even at low levels • No feedback • No undesirable
spillage from other signal sources • No phase cancel-
lations caused by neighboring mics
Setting up and operating the Red Box
• Switch your amp‘s power off. .
• If the mixer desk does not feature phantom power,
insert a 9 V E-block battery or connect a suitable
AC adaptor (refer to „Technical Specications“)
• Connect all cables as illustrated in the diagram.
The Red Box activates as soon as you plug a cable
into the Line In or Speaker In jacks
• Switch your amp‘s power back on. Select one of
the voicing options, 4 x12“ or Combo
• To switch the Red Box off, simply unplug the cable
to the Line In or Speaker In jack. This cuts its
power supply.
To Next Page
Loading...
Need help?
General
