Start Quick Route Navigation
(keypad)
1. Press the GO TO key.
2. Select Quick Route.
3. Use the Joystick to move the cursor to a position or waypoint. Press the
Joystick to mark the first route point.
4. Repeat step 3 to connect more than one route point.
Undo Last Route Point: Press the EXIT key once.
Cancel Route Creation: Press and hold the EXIT key.
5. To start navigation, press the ENTER key.
Cancel Navigation: Press the GO TO key. Select Cancel Navigation.
Open Go To Menu Move Cursor Position Mark Route Points Start Navigation
cursor
marking
a route
point
route
point
9
To Next Page
Loading...
