5
OPERATOR MANUAL HCS-5 020310 5.7.x 03
Fin Safety Information
WARNING!
Before docking, make sure the Humphree system is turned off by the main switch.
WARNING!
Before installation or service, the electrical power to the servo units with dedicated power supply must
be switched off.
WARNING!
Fins must be in neutral position before the boat is lifted out of the water. The lifting device and/or
struts must be placed in such a way that the fins are not damaged. To create a safe workplace in the
area around the ns, it is recommended to have an enclosed area of at least 1.5 x n length 360°
around the n.
WARNING!
There is a risk of being squeezed between the fin and the hull when working in the area of the fin.
Work with caution in the area around the fins.
WARNING!
The fins are rotating when enabled in ZERO SPEED STABILIZATION mode. Swimmers must stay away
from the fins due to the risk of injury. For safety around the vessel, make sure the installer has applied
appropriate warning signs prominently on the hull above the waterline above each fin.
NO SLINGS NO SWIMMING
To Next Page
Loading...
