50
OPERATOR MANUAL HCS-5 020310 5.7.x 03
Service date:
Per for med by:
STAMPED AUTHORIZED DEALER
INTERCEPTOR SERVICE 9
A B C
Calibration of system (below 20Nm in the display)
Re-tighten interceptor bolts to 10Nm
Replace interceptor fastening bolts
Replace interceptor blade
Replace crank assembly
Replace shaft and shaft seals
Polish the interceptor blades
Clean the interceptor blades
Visual inspection and cleaning
Replace seals
Comments:
Service schedule:
RCU-1 RCU-2 RCU-3 RCU-4
Servo information
Total calibration torque (Nm)
Calibration checksum
A B C A B C A B C A B C
Servo position Servo position Servo position Servo position
Replace shaft sleeve kit
Service date:
Per for med by:
STAMPED AUTHORIZED DEALER
INTERCEPTOR SERVICE 10
A B C
Calibration of system (below 20Nm in the display)
Re-tighten interceptor bolts to 10Nm
Replace interceptor fastening bolts
Replace interceptor blade
Replace crank assembly
Replace shaft and shaft seals
Polish the interceptor blades
Clean the interceptor blades
Visual inspection and cleaning
Replace seals
Comments:
Service schedule:
RCU-1 RCU-2 RCU-3 RCU-4
Servo information
Total calibration torque (Nm)
Calibration checksum
A B C A B C A B C A B C
Servo position Servo position Servo position Servo position
Replace shaft sleeve kit
To Next Page
Loading...
