52
OPERATOR MANUAL HCS-5 020310 5.7.x 03
Visual inspection and cleaning
1. Make a visual inspection of the following system components:
● Fins
● Servo units
● RCUs
● Control panel
2. Look through the cables and connectors for possible wear.
3. If needed, use soap and freshwater to clean the servo units.
4. Inspect the anode that is inside of the servo unit (part no 021419).
Replace n bolts and anodes
The n bolts must be removed to access the anode.
The bolt kit also includes one anode (kit part no 021550).
Instructrutions on how to replace the bolts and anodes, see Workshop Manual.
Replace shaft seal kit
Kit part no 022756
For instructions on how to replace the shaft seal kit, see Workshop Manual.
To Next Page
Loading...
