Hunter 50284 - Light Kit Assembly and Installation

8
1886
1886
Installing the Glass
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Ceiling Bracket Hanging Fan Wiring Blades Light Remote Trouble Shooting
Assembling the Light Kit
Insert the third screw, found in the
hardware bag, into place and then
tighten all three screws.
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
2 of 6
bag
Light Kit Screw
1 of 6
bag Light Kit Screw
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
Screw two housing assembly screws from the
hardware bag halfway into the upper switch
housing. It does not matter which two screw
holes you choose.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.Wrap light
kit keyhole slots around the screws and twist
counterclockwise.
Insert the third screw, found in the bag of
materials, into place and tighten the three
screws.