Hunter Avia II - Assembling the Light Kit; Light Kit Wiring and Attachment; Installing the Glass; Globe Installation and Securing

8
1886
1886
Installing the Glass
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Ceiling Bracket Hanging Fan Wiring Blades Light Remote Trouble Shooting
Assembling the Light Kit
After rotating the trim ring
into place, tighten all three
screws securely.
After rotating the light kit into place, tighten all three screws
securely.
Loosen the two pre-installed screws
Loosen the three pre-installed screws
Feed the wire plug through
the center hole of the trim
ring, then wrap keyhole slots
around the screws and twist
counterclockwise. Ensure
screws are engaged in the
keyhole slots.
Connect the plugs from the motor to the light kit.
Make sure to line up the colored markings on the
connectors. Fit light kit keyhole screws onto the
three trim ring screws and twist counterclockwise
to secure light kit into place.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.