www.HunterFan.com
1.888.830.1326
14
M3535-01 • 06/18/13 • © Hunter Fan Company
Light Kit (continued)
Make sure the light kit is securely attached to the mounting
plate. Failure to properly secure all three assembly screws
could result in the light xture falling.
Connect the upper 9-pin plug
connector from the fan to the
lower 9-pin plug connector in the
light kit.
Align the two screw screw holes
and install the switch housing
assembly screws, found in the
hardware bag.
Install the remaining attachment
screw to secure the light kit to
the mounting plate. Securely
tighten all three screws.
Attachment Screw
Install bulb.
To Next Page
Loading...
