www.HunterFan.com
1.888.830.1326
M0096-01 • 04/23/14 • © Hunter Fan Company
19
Troubleshooting
Excessive wobbling
• Tighten all of the blade and
blade ring screws until they
are snug.
• Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
Noisy Operation
• Tighten the blade and blade
ring screws until they are snug.
• Check to see if any of the
blades are cracked. If so, replace
all of the blades.
Fan doesn’t work
• Make sure power switch is on.
• Push the motor reversing switch
rmly left or right to ensure that
it is engaged.
• Check the circuit breaker to
ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 10.
• Turn off power from the circuit
breaker, then ensure the wall
control is properly installed
according to the instructions on
pages 16-17.
To Previous Page
Loading...
Need help?
General