Hunter e36 - Page 100

Hunter e36 • DC Electric
7.8
tery switch panel supplies power to the optional windlass
on your boat. The windlass (shown in Fig. 7.5) offers you
the ability to raise and lower your anchor.
7.3.11.1 To operate the windlass:
Lower Anchor
1. Turn on battery switch.
2. Turn on windlass breaker at DC Panel.
3. Push windlass “Down” button on nav station.
Note: “Bump” switch until anchor clears anchor roller and
hull before letting anchor down freely.
Raising Anchor
1. Start boat engine, this will allow control of boat when
anchor becomes free, as well as reducing load on bat-
tery.
2. Push windlass “Up” button being careful as the anchor
approaches the hull and anchor roller. Continue until the
anchor rests in the stemhead properly.
Note: If it appears there is no power to the windlass,
check reset breaker in stbd. aft cockpit locker. If windlass
becomes inoperable electrically, a manual winch handle
is supplied.
For more information about your windlass, refer to your
owner’s manual.
Figure 7.5
7.3.12 Instruments
The breaker marked “Instruments”, on the 12 Volt DC
Panel supplies power to the instruments on your boat.
For more information about the controls of your instru-
ments consult product manual in your owner’s packet.
7.3.13 GPS (optional)
The breaker marked “GPS”, on the 12 Volt DC Panel
supplies power to the chart plotter on your boat. For
more information about the controls of your instruments
consult product manual in your owner’s packet.
7.3.14 TV/DVD (optional)
The reset marked “TV/DVD”, on the 12 Volt DC Panel
supplies power to the TV/DVD on your boat. For more
information about the controls of your instruments con-
sult product manual in your owner’s packet.
7.3.15 Head (optional)
The breaker marked “Head”, on the 12 Volt DC Panel
supplies power to the Head on your boat. For more
information about the controls of your instruments con-
sult product manual in your owner’s packet.
Anchor tie off cleat
Windlass