12
©2010 Hunter Fan Co. 44086-01 20101102
MAINTENANCE
This fan is permanently lubricated and will not require
additional lubrication (oil) for the life of the fan.
This fan requires little maintenance and contains
no user serviceable parts. DO NOT try to fix
it yourself. Contact qualified service personnel
if servicing is needed.
Before cleaning, turn fan off and unplug from electrical
outlet. Wipe off excess dust with a lintfree cloth. To ensure
adequate air circulation to the motor, keep vents located at
the rear of the motor housing free from dust accumulation.
A vacuum cleaner hose can be used to clean these vents.
DO NOT immerse the fan in water or any other liquid.
CLEANING THE GRILL AND BLADE:
1. Turn the fan off and unplug from the electrical outlet.
2. Disassemble the grills by Loosening the screw holding
the grill ring and remove it from the grills.
3. Two tabs hold the Front Grill and Back Grill together.
Pull the Front Grill forn the back.
4. The blade may be removed by loosening the screw
holding it in place. Grills and blades may be cleaned
with mild soap and water only after they have been
removed from the motor housing.
5. Use a dry or slightly damp lint free cloth to clean
the fan. Use a soft, slightly damp cloth to wipe the
remaining fan parts.
3 DO NOT allow water or any other liquid to get into
the motor housing or base.
3 Reassemble the fan after blades and grills have dried
completely.
3 DO NOT plug the fan into an electrical outlet until it
has been fully reassembled.
To Next Page
Loading...
