22
displayed and the DAYS LEFT icon
will illuminate. The 1 will be blinking
at this point.
3. Press as many times as needed to
set the number of days off desired (up
to 7).
4. To validate this setting
(and to make sure the con-
troller comes back on after
the period is over), turn the
dial back to the RUN posi-
tion at which time, OFF, a number
and the DAYS icon all remain on.
5. Leave the dial in the RUN position.
The days off remaining will decrease at
midnight of each day. When it goes to
zero, the display will
show the normal time
of day and normal
irrigation will resume
at the next scheduled start time.
3) Setting Event Day(s) Off
Programming in a No Water Day(s) is
useful to inhibit watering on mowing days,
etc. For instance, if you always mow the
lawn on Saturdays you would designate
Saturday as a No Water Day so you are
not mowing wet grass.
1. Turn the dial to
the SET STATION
RUN TIMES posi-
tion.
2. Press until the
cursor has moved to
Monday, following
the interval setup.
3. Press to select the
day(s) you would like off.
4. Press to turn the day off.
5. Repeat steps 3 and 4 until all desired
event day(s) are off.
Hidden Features…
1) Programmable Delay Between Stations
This feature allows the user to insert a
delay between when one station turns off
and the next station turns on. This is
very helpful on systems with slow closing
valves or on pump systems that are operat-
ing near maximum ow or have slow well
recovery.
1. Start with the dial in the RUN position.
2. Press and hold the button down
while turning the dial to the SET STA-
TION RUN TIMES position.
3. Release the button. At this point
the display will show a delay time for
all stations in seconds, which will be
blinking. The DELAY icon shall also
be lit at this time.
4. Press the and buttons to increase
or decrease the delay time between 0
and 59 seconds in 1 second increments
and then in one minute increments up
to four hours. HR will be displayed
when the delay changes from seconds
to minutes and hours.
5. Return the dial to the RUN position.
2) Clearing Controller’s Memory/
Resetting Controller
If you feel that you have misprogrammed
the controller, there is a process that will
reset the memory to factory defaults and
erase all programs and data that have been
entered into the controller. Press the , ,
and and hold them down simultane-
ously. Press and release the reset button
then release the , , and buttons.
Time display should show 12:00 a.m. All
memory has been cleared and the control-
ler may now be reprogrammed.
PROGRAMMING
(Continued)
NOTE: The Master Valve/Pump Start
circuit will operate during the rst minute of
any programmed delay to aid in the closing
of the valve and to avoid unnecessary
cycling of the pump. It is recommended
that a pressure relief valve be installed on
the system should this one minute be too
long for a particular system. Consult your
pump contractor or supplier for details.
To Next Page
Loading...
