17
Pro-C Controller
Programming the Controller…
Two key features of the Pro-C that make
programming a snap are its clear, easy-to-
read LCD display and its easy-to-use dial
design.
The Pro-C display shows time and day
when the controller is idle. The display
changes when the dial is rotated to indi-
cate the specic programming information
to enter. When programming, the ashing
portion of the display can be changed by
pressing the or buttons. To change
something that is not ashing, press or
until desired eld is ashing.
The Pro-C controller offers maximum
scheduling exibility including three pro-
grams, each with up to 4 daily start times,
permitting plants with different watering
requirements to be separated on different
day schedules. Multiple start times permit
morning, afternoon and evening watering,
perfect for the establishment of new
lawns and thirsty annual owers. A built
in 365-day calendar clock accommodates
odd/even watering restrictions without
requiring monthly reprogramming. Or, just
simply designate the days of the week you
want to water or use the convenient day
interval watering.
Setting the Current Date and Time…
1. Turn the dial
to the SET
CURRENT
DATE/TIME
position.
2. The current year
will be ashing in
the display. Use
the and but-
tons to change the year. After setting
the correct year, push the button to
proceed to setting the month.
3. The month and day will be in the dis-
play. The month
will be ashing.
Use the and
buttons to change
the month. Press the button to pro-
ceed to setting the day.
4. The day will be
ashing: Use the
and buttons
to change the day
of the month (The day of the week
is automatically selected.) Press the
button to proceed to setting the time.
5. The time will be
displayed: Use the
and buttons
to select AM, PM,
or 24 hr. Press the button to move
to hours. Hours will be ashing. Use
the and buttons to change the
hour shown in the display. Press the
button to move onto minutes. Minutes
will be ashing. Use the and but-
tons to change the minutes shown in
the display. The date, day, and time
have now been set.
Setting Watering Start Times…
1. Turn the dial to
the SET-
WATERING
START TIMES
position.
2. The factory
preset is set on program A. If neces-
sary you can select program B or C by
pressing the button.
NOTE: A basic programming rule is
that whatever symbol or character is
ashing will be the item programmed. For
instance, if the hour is ashing when set-
ting the time, the hour can be changed
or programmed. For illustration purposes,
ashing characters are in Gray type.
PROGRAMMING
To Next Page
Loading...
Need help?
General
