18
3. Use the and
buttons to
change the start
time. (Advances in
15-minute increments.) One start time
will activate all stations sequentially in
that program. This eliminates the need
to enter a start time for each station.
Multiple start times in a program can
be used for separate morning, after-
noon, or evening watering cycles.
4. Turn the dial to SET STATION RUN
TIMES to continue programming the
selected program.
5. Press the button to add an additional
start time, or for the next program.
Eliminating a Program Start Time…
With the dial set to the SET WATERING
START TIMES
position, push the
and buttons until
you reach 12:00 a.m.
(Midnight). From
this position push the button once to
reach the OFF position.
Setting Station Run Times (Length of
Watering for Each Area)…
1. Turn the dial
to the SET
STATION
RUN TIMES
position.
2. The display will show the
last program selected (A, B,
or C) the station number
selected, and the run time for
that station will be ashing. You can
switch to another program by pressing
the button.
3. Use the and buttons to change the
station run time on the display.
4. Press the button to advance to the
next station.
5. Repeat steps 4 and 5 for each station.
6. You may set station run times from 1
minute to 6 hours.
7. You can move between programs
while staying on the same station.
However, it is recommended that one
program is completed before going on
to the next program. Jumping between
programs can be confusing and may
result in program errors.
Setting Days to Water…
1. Turn the dial to the SET
DAYS TO WATER position.
2. The display will show the
last program selected (A, B,
or C) the station number
selected, and the run time for
that station will be ashing. You can
switch to another program by pressing
the button.
3. The controller displays currently pro-
grammed active day schedule informa-
tion. This dial position provides four
different water day options: choose to
water on specic days of the week,
you can choose interval watering, or
choose to water on odd days or even
days. Each program can only operate
using one type of water day option.
PROGRAMMING
(Continued)
NOTE: Regardless of the order in which
the start times are entered, the Pro-C
will always arrange the start times in
chronological order when the dial is
moved off the SET WATERING START
TIMES position.
NOTE: If a program has all four start
times turned off, then that program is off
(all other program details are retained).
Because there are no start times, there
will be no watering with that program. This
is a convenient way to stop watering on
one program only without turning the dial
to the off position.
To Next Page
Loading...
