Hunter Pro-C - Setting Station Run Times

19
Pro-C Controller
Selecting Specic Days of the
Week to Water…
1. Press the Press the
button to activate a
particular day of the
week to water (the
display always starts with Monday).
Press the button to cancel watering
for that day. After pressing a button the
display automatically advances to the
next day. A indicates a water day. A
indicates a no water day.
2. Repeat step 1 until desired days have
been selected.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Selecting Interval Watering…
This feature is convenient if you want to
have a more consistent watering schedule
without having to worry about the day
of the week or the date. The interval
you select is the amount of days between
watering. The days remaining indicates
how many days until the next watering.
For example if you select an interval of 2
with 1 days remaining, watering will begin
tomorrow at the scheduled time.
1. Press the button
with the cursor on
Sunday. Interval
days left, Odd and
Even will appear in the display.
2. Interval is ashing
press the button.
The display will
increment the
interval.
3. Press , the number
of days will be ash-
ing. Use the and
buttons to select
the number of days left until the next
watering.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Selecting Odd or Even Days to Water…
This feature uses a numbered day of the
month for watering instead of specic days
of the week (odd days 1st, 3rd, 5th, etc.;
even days 2nd, 4th, 6th, etc.).
1. Using the instructions for Interval
Watering, set the interval to one.
2. Press the button
until the cursor is
on either EVEN
or ODD in the dis-
play. Select whichever you choose as
No Water Days. If you select ODD
as No Water Days then the controller
will only water on even days of
the month. Conversely, if you select
EVEN as No Water Days then the
controller will only water on odd days
of the month.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Weather Sensor Bypass…
With this built-in feature, there
is no need for an additional
manual bypass switch when
using rain sensors (the Pro-C
works with the Hunter
Mini-Clik
®
, plus some other rain, wind,
and freeze sensors on the market today). If
the system is preventing system operation
(or no sensor is installed and the switch is
in the ACTIVE position), SENSOR OFF
will be displayed. Simply move the switch
to BYPASS and the weather sensor will
be bypassed. This allows you to use the
system.
RAIN SENSOR
BYPASS
ACTIVE
SYSTEM
NOTE: The 31st of any month and
February 29th are always “off” days if
Odd watering is selected.