Hunter Pro-C - Page 22

20
®
Run…
After programming is com-
plete, turn the dial to RUN to
enable automatic execution of
all selected programs and start
times. Watering will not occur
unless dial is in the RUN position.
System Off…
Valves currently water-
ing will be shut off
after the dial is turned
to the SYSTEM OFF
position for two seconds. All active pro-
grams are discontinued and watering is
stopped. To return controller to normal
automatic operation, simply return dial to
RUN position.
Manually Run a Single Station…
1. Turn the dial
to the
MANUAL-
SINGLE
STATION
position.
2. Station run time will
ash in the display.
Use the button to
move to the desired
station. You may then use the and
buttons to select the amount of time for
a station to water.
3. Turn the dial to the RUN position to
run the station (only the designated
station will water, then controller will
return to automatic mode with no
change in the previously set program).
Manually Run All Stations…
1. Turn the dial
to MANUAL-
ALL
STATIONS.
2. You can select program A, B, or C
by pressing the button.
3. Press the button until desired
starting station is displayed.
4. Station run time will ash in the
display. Use the and buttons
to select the amount of run time
for the station to water if different
from the run time displayed.
5. Use the button to move to the
next station.
6. Repeat steps 3 and 4 to customize
each station if desired.
7. Press the button until desired start-
ing station is displayed.
8. Return the dial to RUN (custom pro-
gram will water the entire program
beginning with the station number last
left in the display, then controller will
return to automatic mode with no
change in the previously set program).
One Touch Manual Start and Advance…
You can also activate all stations to water
without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to
program A. You can select program B,
or C by pressing the button.
3. The station number will be ashing.
Press the or button to scroll
through the stations and use the
and buttons to adjust the station run
times. (If no buttons are pressed during
step 2 or 3, the controller will auto-
matically begin program A.)
4. Press the button to scroll to the sta-
tion you wish to begin with. After a 2
second pause, the program will begin.
This feature is great for a quick cycle
RUN
SYSTEM OFF
MANUAL – SINGLE STATION
MANUAL – ALL STATIONS
PROGRAMMING
(Continued)
NOTE: The station that is on the display
when you turn the dial to RUN, will be the
rst station to run. The controller will then
proceed to water in sequential order only.
It will not water previous stations.