Hunter Pro-C - Page 30

28
®
Run Time…
You have the ability to adjust the amount
of time that a station will run once it has
been turned on by your SRR System. This
does not affect the run time programmed
into your controller. This adjustment is
made at the transmitter as described below.
To change the Run Time follow the
steps below:
1. If the unit is OFF (no display), power
the transmitter up by pressing any of
the buttons for at least 1 second then
releasing the button. The transmitter
will rst illuminate the entire display
for 1 second then display the active
station.
2. Simultaneously press the and but-
tons, until the word “RUN TIME”
along with the current Run Time is
displayed (default is 10 minutes). The
display will be blinking at this point.
If more than 5 seconds go by without
a button being pressed, the Transmitter
will revert back to displaying the
active station.
3. Use the or buttons to change the
Run Time to any of 8 settings ranging
from 1 to 30 minutes. Then do not
touch any of the buttons for 5 seconds
and the display will stop blinking, and
return back to the active station.
Activating a Station with the SRR Remote
Control System
The SRR System will allow you to
remotely turn on and off any station on
your Pro-C controller with the press of a
button. Once on, the station will run for
the run time you have designated in the
remote.
To remotely activate a station or pro-
gram follow the steps below:
1. Plug the Receiver into an active wiring
harness (one attached to a powered
controller) and wait for 2 beeps indi-
cating that the Receiver is ready.
2. If your Transmitter is not on (no dis-
play), press any button for at least 1
second and release. The Transmitter
will rst illuminate the entire display,
then display the active station.
3. Use the or buttons to display the
station or program you would like to
start.
4. Momentarily press the “ON” button to
start the station or program. The Trans-
mitter will display the word “TRANS-
MIT” and will ash for about 4 sec-
onds indicating that it is sending the
command to the Receiver. If you are
near the Receiver, you will hear it beep
2 times, indicating that it has received
the command.
5. Press the “OFF” button to turn off
any station that is on. The display will
again read “TRANSMIT” and ash,
and the Receiver will again beep twice.
The SRR System is designed to turn
one station on at a time. Therefore,
turning a station on while another sta-
tion is already on will cause the rst
station to turn off.
Note: The SRR remote can activate any
station on the controller whether the con-
troller dial is in the “System Off”, “Run”
or any other position.
If a sensor device has been wired to the
controller and the rain sensor switch is in
the active position, the SRR remote will
not override the sensor for manual opera-
tion.
Changing the Maximum Station Number
Your SRR Transmitter comes from the fac-
tory with the maximum station number set
to 9. This means that when you use the
and buttons to change the station, you
may change it to any number between
1 and 9. However, if you have a 3 or 6-sta-
tion Pro-C controller, you will not need to
Transmitter Unit
Receiver Unit
INSTALLATION AND PROGRAMMING
(Continued)