Hunter Salido User Manual

7
8
1886
1886
Ceiling Bracket Top housing Hanging Fan Wiring Canopy Blades Light Remote ReverseGlass/Bulbs
Installing the Bulbs and Glass
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Assembling the LIght Kit
Notch
Tab
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the third switch housing screw.
Tighten all three screws securely.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.Wrap
light kit keyhole slots around the screws and
twist counterclockwise.
Screw two housing assembly screws from
the hardware bag halfway into the
upper switch housing. It does not matter
which two screw holes you choose.
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
Screw two housing assembly screws from the
hardware bag halfway into the motor housing.
It does not matter which two screw holes you
choose.
Insert the third screw, found in the hardware bag,
into place and then tighten all three screws.
2 of 3
2 of 3
1 of 3
1 of 3
Light Kit Screw
Switch Housing
Screw
Switch Housing
Screw
Light Kit Screw
bag
bag
bag
bag
Fan style may vary.
Note:

Hunter Salido Specifications

General

Brand	Hunter
Model	Salido
Category	Fan
Language	English