37
Error Mode
■ If the thermostat is unable to control your system due to an unex-
pected battery problem, the thermostat will enter Error Mode. In
this condition, the thermostat flashes “Err” on the LCD display, and
shuts off your system. To correct this problem, replace the batteries
with 2 new AA alkaline batteries, even if you have recently replaced
them. Next, use a paper clip to press the RESET button next to the
keypad. You will need to reprogram your thermostat and confirm
normal operation.
■ If Error Mode returns, please call Hunter Technical support at
1-866-268-1936 for further information.
Auto Cut Off
Your thermostat will automatically cut-off in Heat
mode if the room temperature rises above 35˚C (95˚F).
It will cut-off in Cool mode if the room temperature
drops below 4˚C (40˚F).
NOTE:
If your system has malfunctioned and no
longer responds to thermostat controls, the Auto
Cut-Off will have no effect.
41665-01.pmd 9/30/03, 4:53 PM37
To Next Page
Loading...
Need help?
General
