www.HunterFan.com
1.888.830.1326
Remote Control
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. The
battery should be installed with the positive
(+) side up. Replace with a CR2032 battery
when necessary.
Phillips
Head
Screw
Battery
Door
ON
Turn Power
The remote transmitter is already paired
to the receiver and ready to use.
Note: If your need to pair your remote, cycle power
to the fan by turning power off and back on at the
wall switch (or circuit breaker if necessary). Within
three minutes, press and hold both the Fan OFF
button and the Fan ON button for four seconds
to pair the remote. To prevent faulty operation,
please disconnect power from all other ceiling
fans within range while pairing.
15
M3644-01 • 02/01/17 • © 2017 Hunter Fan Company
To Next Page
Loading...
